Concrete Steps Construction in Marysville WA - an entry that stays level through winter
Steps cracking, sinking or pulling away from the house? We build new ones on a footing set for winter, joined cleanly at the wall.
- Licensed and fully insured.
- Free quotes on site.
- Expect a reply within 1 business day.
What goes into building new concrete steps in Marysville?
Concrete steps construction in Marysville means building new entry steps from poured or precast concrete, set on a footing deep enough to ride out a freeze and joined cleanly to the slab or house they meet, so you get a solid, level way in and out.
Most calls start with old steps that have cracked, sunk or begun to lean away from the house, or a new door that needs a way down to the yard. The price mostly moves with poured or precast, how tall the rise is, how deep the footing has to go and whether the steps tie into a slab or the house wall, and the schedule turns on the weather and any permit questions for your address. I'll give you your own figure in a written estimate once I've measured.
How can you tell your concrete steps need replacing?
A gap at the house
When a crack opens where the steps meet the foundation, the steps are usually settling or were poured tight to the wall with nothing to let them move. Water runs into that gap and freezes, so it widens every winter and sends more water toward your foundation.
Steps tilting or sinking
Treads that lean or sit lower on one side usually mean the base underneath settled or the footing is too shallow. The longer it goes, the more uneven each step gets, and the harder it is to meet the door and the slab cleanly with a new set.
Flaking, crumbling edges
A surface that peels off in flakes or edges that break away usually comes from water soaking into the concrete and freezing over and over. Once the top is open, more water gets in each winter and the damage moves deeper.
How we handle concrete steps construction
On a steps job, the work that counts starts below ground. I measure the total rise and look at what the steps have to meet, then walk you through poured or precast for your height so you don't pay for forming you don't need. We break out any old steps, dig the footing down past where the ground freezes and pack the base, the dirt and gravel the concrete sits on, so it doesn't settle later. For poured steps we build the forms and set rebar, steel bars that keep the concrete tied together if it cracks, then pour and give the treads a broom finish, a light gritty texture that gives your feet some grip when they're wet. Where the steps meet the house, we leave a filled joint so the two can move on their own instead of cracking each other, and the concrete then cures, the slow hardening that sets its strength, before anyone uses it. If the budget gets tight, I'd rather spend it on the footing and that joint than on a fancier finish, because you can redo a surface later but you can't fix what's under the steps without tearing them out.
Steps rarely stand alone, so we often plan them with the work next to them. If you're adding a room or a garage on a new slab, our slab foundation building can set the landing height for the steps from the start, and on a new house or a replacement, foundation installation lets us work out the step footing and the house footing together.
Poured in place steps
Built in forms on your site, these fit any rise and can tie into an existing slab or landing. They suit older houses where the door sits at an odd height.
Precast steps
Made ahead in set sizes and placed on a new footing, precast is a good fit when your height lines up with a standard size. Setting them is quicker work because the forming is already done.
Replacing a worn-out set
When old steps have sunk or pulled away, we break them out and look at why before anything new goes in. The new set starts from a proper footing instead of patching over the cause.
Get a written estimate for your new concrete steps
We'll reply within one business day to set a time, and I'll come out to measure at no charge. You get a written estimate showing what's included and what isn't, with no obligation to go ahead.
(360) 251-0089- Based in
- Marysville, WA 98270
- Hours
- Mon–Fri: 7 AM–9 PM, Sat–Sun: 6 AM–9 PM
What happens after you call about new steps?
Here's how a steps job runs from your first call to the final walk-through, and what you'll have in hand before you decide anything.
Call or send the form
Reach us at (360) 251-0089 or through the form with a few details about your steps. The number of steps, the total height and whether they meet a slab or the house wall help me plan the visit.
Site visit and written estimate
I look at the site, measure the rise and ask how you use that door. You then get a written estimate that says plainly what's included and what isn't, so you know what the price covers before you commit.
Permits, then form and pour
Once you say go, we settle any permit question first. Then our crew digs the footing, forms, pours and finishes the steps.
Walk the job together
We clean up and haul off the old concrete. Then I walk the finished steps with you so you can see the joint at the house and the finish before we leave.
Why Marysville homeowners call Classic Marysville Concrete for steps
I measure your steps myself
I usually come out to look at the job and measure, and a small crew I've worked with for years does the forming, pouring and finishing with me on site. The person who planned your footing depth is there when it's dug.
Nine years of awkward jobs
We've been in business since 2017, and we're best known for the tricky ones, like new steps that have to meet an old slab at an odd height. I'd rather explain a trade-off before the pour than after it.
Licensed and insured in Washington
We're licensed and fully insured. Washington requires construction contractors to register with L&I, and you can look any of them up before hiring with the state's Verify a Contractor tool.
The footing and the joint at the house decide how new steps hold up, so let's look at yours before anything gets poured. Request an estimate or call (360) 251-0089.
Concrete steps and the work around them in Marysville
Whether your steps need a permit depends on the job and your address, and the office can be the City of Marysville or the county, so I'll tell you early which one covers you. Inside the city, building permit applications all go through its online Permit Portal, and we can help with the application and work to the inspections that come with it. If you'd like to ask before we start, a Permit Technician at the city's Permit Services Center answers questions at 360.363.8223 or MsvlPermits@marysvillewa.gov.
Outdoor steps here stay wet and freeze and thaw over and over, and Snohomish County rates weathering in this area as moderate to severe. Concrete with tiny, evenly spread air bubbles can give that freezing water room to expand, so on steps the mix matters as much as the footing, and we see the same wet winters on jobs in Lake Stevens and Everett.
Questions about concrete steps in Marysville
Should I get poured or precast concrete steps?
Precast usually costs less when your total height matches a standard size, and poured is the better fit when the rise misses those sizes or the steps need to tie into an existing slab. Poured steps cost more because of the labor to build the forms. I'll measure your height and tell you which one makes sense.
How deep should the footing for concrete steps be in Marysville?
The footing should reach at least the local frost depth, and Snohomish County lists that frost line at 18 inches. Where the ground freezes and thaws, a step footing that stops above the frost depth will heave and crack. Ask any contractor you talk to how deep they plan to dig, and I'll tell you ours before you decide.
Can concrete steps be poured in cold weather in Marysville?
Yes, with a plan to keep the fresh concrete from freezing, since new concrete should stay unfrozen for at least the first 24 hours after it's placed. The ground under it should also be compact, not frozen, and clear of snow, ice and frost. In winter that can decide which day we pour.
How much do concrete steps cost near Marysville?
Installing concrete steps in the Seattle area usually runs about $700 to $5,500 per job. Where yours lands depends on poured or precast, the total height, how deep the footing goes and whether old steps have to come out first. For a Marysville price, I'll come out, measure and send you a written estimate.
What causes concrete steps to crack, and will new ones crack the same way?
New steps shouldn't fail for the same reason if the cause is found, and the cause is usually a shallow footing, a base that settled or steps poured tight against the house. That's why I look at what's under the old set when we break it out and plan the new footing and joint around what we find.
How long do I have to stay off new concrete steps?
Stay off them until the concrete has cured enough to take weight, and cold, damp weather slows that down. I'll tell you when they're ready before we leave, and until then it's best to plan on using another door.
Foundation work that pairs with new steps
Slab foundation building
If you're adding a room or outbuilding, the slab and its steps can be planned together so the landing heights line up and the footings work as one.
Foundation installation
Building new or replacing a foundation? Setting the step footing at the same time saves digging twice and lets us plan the joint where steps meet the house.
Cities where we build concrete steps
Classic Marysville Concrete is based in Marysville, WA, and builds steps in Arlington, Mill Creek and the cities around them. The 12 cities below each have their own page, and they aren't the only places we work.
Marysville, WA
Book a time to measure your steps
Calling before the weather turns leaves time to settle any permit question and pick a pour day that won't freeze the fresh concrete.